Features
1Continuous monitoring
The current humidity is constantly compared with the threshold.
2“Ventilate!” message
As soon as the threshold is exceeded, the status shows “Ventilate!” instead of OK – at a glance.
3Adjustable threshold
Freely selectable from 0 to 100 %.
4Notification delay
0 to 30 minutes, so that short peaks, e.g. when showering, don’t trigger a message.
5Notification to your phone
If you wish, a push message via the app, optionally with a target page to tap.
6Automatic reset
If the value falls below the threshold, the status is reset – a new message is then possible again.
Module details
Technical details: instance configuration 5 fields
| Source (actual humidity) | Sensor variable (integer or float in %). Also appears as the object link “Humidity” with the profile ~Humidity.F. |
|---|---|
| WebFront selection | The WebFront instance for push messages. |
| Target page (optional) | Target ID opened when the notification is tapped. |
| Push messages on/off | Switches sending on or off. |
| Variables in the instance | Status, threshold (in %) and notification delay (in minutes). |
Setup step by step 6 steps
- Choose the sensor variable.
- Set the threshold, e.g. 60 % – depending on the room.
- Set the notification delay, e.g. 5–10 minutes, to ignore short peaks.
- Check the status: if exceeded, it changes to “Ventilate!”.
- Activate push: choose the WebFront, optionally set a target page, switch push on.
- Automatic reset: if the value falls below the threshold, the status is reset.
Frequently asked questions 1 question
Why does the status stay on “Ventilate!”?
Check the sensor and threshold. The status only returns to OK when the actual value falls below the threshold again.
Questions, or need your own logic?
info@stegmann-smarthome.deWe adapt modules – e.g. for additional sensors, bus systems or visualisations.
Interested in the Humidity monitoring module?
We set it up for you and adapt it to your building.